How long does it take to pump out a flooded house?
Bulk pumping of a room or crawl space is often a matter of hours, and extraction from materials takes longer than the pumping did. Access, depth, the number of rooms and the discharge route all change the figure, so a crew gives you a time once they can see the space.
What slows a job down is rarely the volume of water. It is the way to the water: a crawl space reached through one hatch, a flooded shop packed with stock, a stairwell that has to be cleared before hose can be run. Those conditions can double the hours without changing a litre of water.
The useful detail on a first call is depth, rooms affected and whether a crawl space or basement is involved. That is what decides which equipment comes on the truck, and sending the right kit first time is most of the speed in this trade.
Can I just use a wet vacuum or a shop pump myself?
A household wet vacuum removes surface water and nothing more. It cannot pull water out of pad, slab or framing, and it will not tell you where the water went. If the water is contaminated or anywhere near electrics, the risk is not worth it; get the power off and make the call.
Homeowner pumping also goes wrong at the discharge end. Water pushed out beside the foundation or into a yard that is already saturated comes back under the building, which is a common reason a crawl space refills overnight after someone emptied it the day before.
What you can do safely is switch off affected circuits, move what can be lifted, photograph the rooms before anything moves, and keep people out of the water. Leave the structural judgment until the readings exist.
Where does the pumped water go?
To a lawful discharge point away from the building, chosen so that it leaves the site rather than returning through the ground. Clean water and contaminated water are not handled the same way, and water with sewage in it is treated as the contaminated job it is from the start.
Discharge planning is one of the things that separates a managed job from a hurried one, especially during a long storm when the ground is already full and every nearby drain is working hard. In the December 2025 atmospheric river the city reported flooding on Mill Creek, Shelton Ditch and lower Pringle Creek at the same time, which is the kind of day when there is nowhere obvious to put water.
If the water in the building came from a sewer backup, the extraction is a different job with different protective equipment, covered on the sewage backup cleanup page.
What moves the cost of extraction and pumping up or down?
The depth and area of water, how many rooms and levels it reached, how hard the space is to reach, how long the water sat, the type of water, and whether a crawl space or pit is involved. The scope is written on site, explained, and approved by you before work begins.
Two jobs with the same floor area can look nothing alike on paper. A single-level house with a truck parked at the door and three inches of clean water is a straightforward extraction. The same area spread across a crawl space, a garage and a hallway, with silt in it, means more equipment, more labor and more hours.
We publish no price figures for this work, because a number without a site visit is a guess. What is promised is that nothing is done until the scope and the price are explained and you have agreed to them.